JVC HM-DSR100RU manual User and Installation Guide, What Is, Possible Why, What to Do, Happening

User and

Installation Guide

USE THE REMOTE CONTROL

What Is	Possible Why	What to Do
Happening
You cannot find the		Use the front panel control buttons to operate the recorder until
remote control.		you find the remote.
		If the remote control is permanently lost or too damaged to use,
		call the Service Center to order a replacement.
When you press a	The remote control may be missing	If the batteries are missing or dead, insert four fresh AAA-size
button on the remote	batteries, the batteries may be	batteries.
control the behavior is	incorrectly placed in the remote, or	Make sure to re-initialize and reprogram the remote, including
not as expected.￿Instead,	the batteries may be weak or dead.￿	resetting the remote address if necessary.
you may see one of the	If a button on the remote is pressed	If the remote has fresh batteries, check whether they are placed
following:	that has no function for the active	according to the label diagram. If not, remove them and place
No mode light (SAT,	mode, the mode light may not	correctly.
	flash.
TV, D-VHS or AUX)
flashes.
The remote changes to
SAT mode.
The other equipment
does not respond.
￿The mode lights may or
may not flash.
When you try to control	The other equipment may not be	Power the equipment ON. Reposition the remote so that it has a
equipment other than	powered ON.	clear line-of-sight to the equipment.
the recorder with the	The remote may not be in the	Check the remote batteries. If necessary, re-install and make sure
remote, the other	correct mode.	they are firmly seated.When you press a button on the remote,
equipment does not	If the remote is in the correct mode,	note which of the remote mode lights flashes. If the remote is not
respond.	it may not be programmed for this	in the correct mode, press the Mode button until the correct mode
	particular brand of equipment.	light flashes. Program the remote with the correct code for the
	The batteries may not be properly	equipment. Try the Power Scan method, if necessary.
	installed.
	There may be a solid object
	between the remote and the
	equipment, or the remote is not
	aimed directly at the equipment.
The remote control does		1. Turn the VCR's power OFF if its power is ON.
not work when the		2. Press the Mode button until the remote is in the D-VHS mode.
remote is in the D-VHS
		3. Press the Address button. The D-VHS light blinks.
mode. ￿
		4. Use the number pad buttons to enter "222".
		5. Press the Address button. The D-VHS light blinks.
		6. Load a cassette into the cassette loading slot. The VCR's
		power comes on automatically.
		7. Make sure that playback starts when the Play button is
		pressed. If playback does not start, repeat steps 1 through 7.

Page A-12