JVC HM-DSR100U, HM-DSR100DU, HM-DSR100RU manual Getting Started, Using The Remote Control

3 Getting Started

USING THE REMOTE CONTROL

INSTALLING BATTERIES IN THE REMOTE

The remote control is shipped with four AAA batteries, packaged separately. When you replace old batteries, you should replace all four batteries. Use four batteries of the same grade, for example, alkaline or carbon zinc, and do not mix batteries of different grades. Alkaline batteries provide longer battery life. Any time you remove or install the batteries, you may have to reprogram the remote for the TV and any other electronic components. See Programming the Remote Control on page 4-39 for the procedure to reprogram your remote.

1.Press down on the slot in the battery case cover (on the back of the remote) and remove the cover.

2.If you are replacing old batteries, remove and replace all four batteries.

3.Insert the new batteries, making sure to match the plus (“+”) ends with the plus indicators on the remote. The batteries alternate plus and minus (“–”) ends when properly seated.

4.Replace the cover by inserting the tabs into the slots, and snapping the cover into place.

Battery Cover

Back of

Remote

Batteries

If the remote does not work after installing the batteries, confirm that the batteries are properly seated, with the plus and minus ends aligned correctly. You may need to reprogram the remote. See Programming the Remote Control on page 4-39.

Page 3-1