JVC HM-DSR100RU User and Installation Guide, indicates a second TV 1 - indicates a second VCR

User and Installation Guide

5.Use the number pad buttons to enter the first 3-digit code listed for your equipment brand in the table. The mode light stops flashing and stays lit.

Note: If you are entering a code for the AUX mode, you have to enter a four-digit code. The first digit is the code for the piece of equipment:

0 - indicates a second TV

1 - indicates a second VCR

For example, to program the AUX mode to control a Sony TV, enter 0 and then 000.

If you are programming for an amplifier or cable TV box, the codes shown in the table include the first digit.

6.Press the Address button. If the code you entered is valid, the mode light blinks three times.

7.Test if the code works for the equipment by pressing the Power button. If it is the correct code, the equipment should turn OFF.

8.Turn the equipment back ON and try some other functions to make sure you have the correct code. Occasionally the Power button may work when others do not.

If the code works, then you can stop here. Write all the codes you programmed into the remote on the sticker on the inside of the remote battery cover, and on the inside back cover of this Guide.

Note: When you change the batteries in the remote, you may need to reprogram these codes back into the remote.

9.If the code you entered is not correct, repeat steps 4 through 8, using another code from the table.

10.If you have tried all of the codes listed for your equipment without success, or if you cannot find your equipment manufacture's name in the table, do the procedure in The Power Scan: If Your Brand is Not Listed on the next page.

Note: You have a limited time to program the remote

control after pressing the Mode button. Start the programming procedure again if the mode indicator is no longer lit.

1 2 3

4 5 6

7 8 9

0

ADDRESS

POWER

Page 4-40