Installing and Wiring Your System | 7 |
Installing the Satellite Antenna |
11.Thread the LNBF cable into the cable hole near the mast foot, up the mast and out the top of the mast.
Do not kink or pinch the cable.
12.Take the end of the cable coming out the top of the mast, and thread it up the support arm.
13.Loop the end of the cable over the pivot bolt.
14.Bring the cable back down on the outside of the mast sleeve, between the dish supports.
15.Thread the cable through the arm and out the end of the arm.
16.Adjust the cable so that there are about 2 inches of cable out the end of the arm.
17.Attach the LNBF to the coaxial cable(s).
18.Fit the LNBF into the dish support arm, sliding it in until it is inserted firmly. You may have to adjust the cable, pulling it back gently through the support arm.
2"
Dish
Support
Arm
Mast
Coaxial
Cable
Cutaway View (dish omitted for clarity)
Cutaway
View of Arm
LNBF
Connectors
Coaxial
Cable
Cable
Loop
Pivot
Bolt
Mast
Sleeve
Direction to Thread Coaxial Cable
Mast
Foot
LNBF
Connector
Coaxial
Cable
Cutaway
View of Arm
19.Attach the LNBF to the support arm, using the LNBF screw and washer.
Cutaway
View of Arm
Washer
Screw
Page
