JVC HM-DSR100U, HM-DSR100DU, HM-DSR100RU manual Changing Modes on the Remote

User and

Installation Guide

CHANGING MODES ON THE REMOTE

Use the Mode button to set the remote to control other electronic components, such as your TV. See Mode Button on page 2-9 for more information. To change modes, do the following:

Press the Mode button on the remote repeatedly until the appropriate mode light flashes rapidly.

For example, to control the built-in satellite receiver, make sure the SAT light is flashing. Or for the D-VHS

MODE

SAT TV D-VHS AUX

mode, which is used to control the built-in video recorder and local timer, the D-VHS light should be flashing.

TV/VCR

POWER

SETTING THE REMOTE ADDRESS

If your recorder turns ON or OFF, or does anything else without you pressing any buttons, it may be responding to signals from another nearby remote control. To prevent undesired operation of your recorder by a neighbor’s remote, you can address your remote to the recorder. You may choose from 15 different addresses.

Note: If your remote is addressed to the recorder, you may need to reprogram this address when you change the batteries in the remote.

Remote Buttons

1.Make sure that fresh batteries are installed in the remote.

2.Press the Mode button until the remote is in SAT mode. The SAT mode light flashes rapidly to indicate the mode.

3.Press the Address button once. The SAT mode light continues to flash, but at a slower rate.

4.Enter a number from 1 to 15 using the number pad buttons. The SAT mode light stops flashing and stays lit.

Note: Do not put a zero before the number when entering this number.

MODE

ADDRESS

1 2 3

4 5 6

7 8 9

0

Page 3-2