JVC HM-DSR100U, HM-DSR100DU, HM-DSR100RU manual Ordering Your Programming

Installing and Wiring Your System	7
Ordering Your Programming

ORDERING YOUR PROGRAMMING

This procedure notifies the Service Center that your system is on-line and installed. You need to have your services activated before you can start enjoying your desired programming. You must authorize your services when you first install your system, and whenever you request to add or remove services.

All you need to do is call to notify the Service Center that your system has been installed and you would like to begin receiving programming. The Service Representative will explain the available program packages and services. You can then select the services that you want to authorize.

You will need to give the Service Representative information about your system. To get this information, do the following: Power the recorder OFF, using the remote control Power button (not the recorder Power button). Then, press the Info button on the recorder or remote. This will display the Important System Information menu, as shown below. To exit this menu, press the Select button on the recorder or remote.

Note: The recorder is still OFF. You will have to press the Power button on either the remote or the recorder to turn the recorder back ON.

					Info screen
					Title
Receiver				Important System Information
Condtional
Access				Model ID : IRR			Model ID
Number				Receiver CA ID : R0016825089-94
			Smart Card CA ID : S0000278950-56				SmartCard
Software				DNASP002 Rev052			Conditional
			Software Version : 205PBTAA-F				Access Number
Versions	Boot Strap Version : 100BBTAA
		Customer Service : 1-800-333-DISH (3474)					Access to
Remote			Internet Address : http://www.dishnetwork.com				Assistance
			Remote Address : 9
Control
Address	Copyright © 1996, EchoStar Communications
						OK	Press Select
				Corporation. All Rights Reserved.

to Exit Info Screen

The Service Representative will authorize your programming signal using the satellite signal. This includes checking that the Smart Card is properly inserted in the recorder.

When the services are authorized, you should see channels other than the Preview Channel.

SERVICE CENTER PIN

As an option, the Service Representative will ask you if you want to set up a Service Center Personal Identification Number (PIN). See Service Center Security on page 4-29 for more information.

Page 7-17