JVC HM-DSR100U, HM-DSR100DU, HM-DSR100RU manual Determining the Current Remote Settings

Using the System	4
Programming the Remote Control

DETERMINING THE CURRENT REMOTE SETTINGS

You can find out which code is currently set for each remote mode.

		Remote Buttons
1.	Press the Mode button on the remote until the	MODE
	appropriate mode light is flashing rapidly.
2.	Press the Address button twice.	ADDRESS

For SAT mode, the mode light flashes the number of times that matches the recorder address.

For example, if the recorder is addressed to 4, the mode light flashes four times.

For TV, D-VHS, and AUX modes, the mode light flashes the number of times to indicate each digit of the current code. There will be a pause between the flash sequences for the digits. A quick flash indicates zero (0).

For example, for an AUX code of 0136, the mode light flashes once quickly (for zero), then once, three times, and six times.

Note: Remember that the AUX mode has a 4-digit code.

3.Write all the codes you programmed into the remote on the sticker on the inside of the remote battery cover, and on the inside back cover of this Guide.

Note: When you change the batteries in the remote, you may need to reprogram these codes back into the remote.

Page 4-43