Getting Started | 3 |
Using the Remote Control |
5.Press the Address button to save the new address in the remote memory. If the address you entered is valid for your remote, the SAT mode light blinks three times.
6.If the recorder is ON, turn it OFF using the recorder Power button.
7.Wait for 15 seconds to allow the recorder to reset.
8.Press the Info button on the recorder. This will display the Important System Information menu.
ADDRESS
Important System Information
Model ID : IRR
Receiver CA ID :
DNASP002 Rev052
Software Version :
Internet Address : http://www.dishnetwork.com
Remote Address : 9
Copyright © 1996, EchoStar Communications |
| OK |
Corporation. All Rights Reserved. |
| |
|
|
|
9. Press the Rec(ord) button on the remote.
The remote address displayed on the Important
REC System Information menu will change to indicate
that the recorder address now matches the remote address.
Page
