Removing an adapter
Rear adapter retention bracket
Adapter
Front adapter retention bracket
To remove an adapter, do the following:
1.Read the safety information that begins on page 5.
2.Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3.Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
4.Unlock and remove the
5.Rotate the adapter retention brackets to the open position.
6.Disconnect the cables from the adapter.
7.Remove the screw that secures the adapter to the server chassis.
8.Pull the adapter out of the adapter connector; then, lift the adapter out of the server.
9.If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Installing an adapter
The following notes describe the types of adapters that the server supports and other information that you must consider when you install an adapter:
vLocate the documentation that comes with the adapter and follow those instructions in addition to the instructions in this section. If you must change the switch or jumper settings on the adapter, follow the instructions that come with the adapter.
184ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
