![](/images/new-backgrounds/1102911/102911429x1.webp)
9.Close the bezel (see “Closing the bezel” on page 151).
10.Install and lock the
11.Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
Removing an extender card
Extender card retaining screws
To remove an extender card, complete the following steps:
1.Read the safety information that begins on page 5.
2.Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3.Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
Chapter 7. Installing optional devices and replacing customer replaceable units 207