| Troubleshooting tables | |
| Use the troubleshooting tables to find solutions to problems that have identifiable | |
| symptoms. | |
| If you cannot find a problem in these tables, see “Running the diagnostic programs” | |
| on page 90 for information about testing the server. | |
If you have just added new software or a new optional device and the server is not | ||
working, complete the following steps before you use the troubleshooting tables: | ||
1. | Check the operator information panel and the EasyLED diagnostics LEDs (see | |
| “EasyLED diagnostics” on page 76). | |
2. | Remove the software or device that you just added. | |
3. | Run the diagnostic tests to determine whether the server is running correctly. | |
4. | Reinstall the new software or new device. | |
DVD drive problems
vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
vSee Chapter 8, “Parts Listing, TD200x Machine Types 3719, 3821, 3822, and 3823,” on page 237 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.
Symptom | Action | |||
|
|
|
| |
The DVD drive is not | 1. | Make sure that: | ||
recognized. | ||||
| v The SATA channel to which the DVD drive is attached (primary or | |||
|
| |||
|
|
| secondary) is enabled in the Setup utility. | |
|
| v All cables and jumpers are installed correctly. | ||
|
| v The signal cable and connector are not damaged and the connector pins are | ||
|
|
| not bent. | |
|
| v The correct device driver is installed for the DVD drive. | ||
| 2. | Run the DVD drive diagnostic programs. | ||
| 3. | Reseat the following components: | ||
|
| a. | DVD drive | |
|
| b. | DVD drive cables | |
| 4. | Replace the following components one at a time, in the order shown, restarting | ||
|
| the server each time: | ||
|
| a. | DVD drive | |
|
| b. DVD drive and cables | ||
|
| c. (Trained service technician only) System board | ||
|
|
|
| |
A DVD is not working correctly. | 1. | Clean the DVD. | ||
| ||||
| 2. | Run the DVD drive diagnostic programs. | ||
| 3. | Reseat the DVD drive. | ||
| 4. | Replace the DVD drive. | ||
|
|
|
| |
64ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
