Connecting the cables
Notes:
1.Be sure to turn off the server before you connect any cables to or disconnect any cables from the server or
2.For additional cabling instructions, see the documentation that comes with the optional devices. It might be easier for you to route any cables before you install certain optional devices.
3.Cable identifiers are printed on the cables that come with the server and optional devices. Use these identifiers to connect the cables to the correct connectors. For example, the hard disk drive cables are labeled “HDD option.”
The following illustration shows the locations of the input and output connectors on the rear of the server.
USB 1
USB 2
USB 3
USB 4
Ethernet 10/100/1000 Power cord connector
Serial 1 (COM 1) Systems management
Updating the server configuration
When you start the server for the first time after you add or remove a device, you might receive a message that the configuration has changed. The Setup Utility starts automatically so that you can save the new configuration settings. For more information, see Chapter 9, “Configuring the server,” on page 251.
234ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
