Lenovo 3821, 3822, 3719, 3823 manual

14.If the tape drive came with screws, secure the drive to the server chassis, using the supplied screws.

SATA optical drive power connector USB signal cable connector

USB signal cable

SATA optical drive power cable (SATA-to-traditional power connector cable also included. Not pictured.)

SATA optical drive signal cable

15.Connect one end of the tape drive cable to the USB or SATA connector on the system board, depending upon the type of tape drive that you are installing; then, route the cable through the cable holders on the inside of the server and connect the opposite end of the cable to the back of the tape drive.

Note: If you are installing an RDX internal USB tape drive, use the SATA-to-traditional power converter cable to serve as a bridge between the optical power cable and the power connector on the RDX tape drive.

16.Connect the power cable to the tape drive and to the connector on the system board (see “Internal cable routing and connectors” on page 163 for more information.)

17.Reinstall the fan-cage assembly.

18.Reinstall the air baffle (“Installing the air baffle” on page 170).

19.Reinstall or close the power-supply cage (“Closing the power-supply cage” on page 160).

20.Reinstall the power supplies (“Installing a hot-swap power supply” on page 175).

21.Replace the left-side cover; then, lock the side cover and bezel.

22.Reconnect the external cables and power cords.

192ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual