1.Touch the
2.Hold the system board by the handles and insert the system board into the chassis at an angle; then, slide it toward the rear of the server.
Note: Make sure that none of the server cables are caught under the system board.
3.Press down on the retention modules; then, rotate the release lever toward the rear of the chassis to secure the system board.
4.Install any of the following components that you removed from the system board:
v Microprocessors and heat sinks (see “Installing a microprocessor and heat sink” on page 220).
vDIMMs (see “Installing a memory module” on page 211).
vExtender card (see “Installing an extender card” on page 209).
vAdapters (see “Installing an adapter” on page 184)
vBattery (see “Installing the battery” on page 173).
5.Reconnect any cables to the system board that you disconnected during removal (see
6.Install the
7.Install the air baffle (see “Installing the air baffle” on page 170).
8.Return the
9.Install the power supplies (see “Installing a
10.Install and lock the
11.Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
Completing the installation
To complete the installation, do the following:
1.Insert the bezel hinges into the slots on the server chassis and close the bezel (“Closing the bezel media door” on page 156 and “Closing the bezel” on page 151).
2.Position the
3.Place the bottom edge of the cover onto the bottom edge of the server.
4.Rotate the top edge of
5.Rotate the bezel to its fully closed position.
6.Using the supplied key, lock the
7.Connect the cables and power cords. For more information, see “Connecting the cables” on page 234.
Chapter 7. Installing optional devices and replacing customer replaceable units 233
