Lucent Technologies 7820-0802-003 manual Configuring OC3-ATM Cards MAX TNT/DSLTNT

Configuring OC3-ATM Cards (MAX TNT/DSLTNT)

Overview of OC3-ATM settings

rx-descramble-disabled = no tx-scramble-disabled = no rx-cell-payload-descramble-disabled = no tx-cell-payload-scramble-disabled = no loop-timing = yes

vpi-vci-range = 0-15/32-4095 clock-source = not-eligible clock-priority = middle-priority

traffic-shapers = [ { no 1000 1000 2 no 0 } { no 1000 1000 2 no 1 } {+

Parameter	Specifies
Name	Name of the interface. The default value is the interface address in
	shelf:slot:item format (for example, 1:2:3), but you can assign
	a text string of up to 16 characters.

Physical-Address

Enabled

Physical address of the OC3-ATM port in the TAOS unit unit.

Enable/disable the OC3-ATM interface. (Disabled by default.) When the OC3-ATM interface is disabled, it transmits the OC3-ATM Idle Signal to the far end.

Trunk-Group	Not currently used. Leave the default value (zero).
Nailed-Group	Nailed-group number for the OC3-ATM physical interface. A
	Connection or RADIUS profile specifies this number to make use
	of the interface. Each interface must be assigned a number from 1
	to 1024 that is unique within the system.

Call-Route-Info

Loopback

Not currently used. Leave the default value (the zero address).

Enable/disable loopback for diagnosing connectivity or possible equipment problems. Loopback is disabled by default, which is required for normal operations.

Framer-Mode	Frame format for data transmitted on the interface. Valid settings
	are sdh (the default) and sonet, which represent the
	synchronous digital hierarchy (SDH) and synchronous optical
	network (SONET) frame formats, respectively.
Framer-Rate	Framing operations. Only the default STS-3Csetting is used,
	which represents both the 155.52Mbps interface in the U.S. and
	the equivalent European 155.52Mbps interface (STM-1).
Rx-Descramble-Disabled	Enable/disable descrambling of the entire receive stream. This
	function is enabled by default. Disable it by setting this parameter
	to yes only if the far-end switch has disabled the corresponding
	functions.
Tx-Scramble-Disabled	Enable/disable scrambling of the entire transmit stream. This
	function is enabled by default. Disable it by setting this parameter
	to yes only if the far-end switch has disabled the corresponding
	functions.
Rx-Cell-Payload-	Enable/disable descrambling of the 48-byte ATM cell payload in
Descramble-Disabled	received cells. This function is enabled by default. Disable it by
	setting this parameter to yes only if the far-end switch has
	disabled the corresponding functions.

15-2 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide