Lucent Technologies 7820-0802-003 manual Configuring the IP-Route profile

Configuring DSL Connections (DSLTNT)

Sample DSL configurations

admin> set local-address=192.168.23.142/30

7List the submenu for Frame Relay options: admin> list .. fr-options

[in CONNECTION/sdsl-pipeline:fr-options] frame-relay-profile = ""

dlci = 16 circuit-name = "" fr-direct-enabled = no fr-direct-profile = "" fr-direct-dlci = 16

8Link this Connection profile to the Frame-Relay profile you will create in the next section: admin> set frame-relay-profile=fr-prof-1

9Set the DLCI to the same value as the DSLPipe-S: admin> set dlci=16

10Open the Telco-Options subprofile: admin> list .. telco-options

[in CONNECTION/sdsl-pipeline:telco-options] answer-originate = ans-and-orig

callback = no call-type = off nailed-groups = 1 ft1-caller = no force-56kbps = no data-service = 56k-clear

..

..

11Specify that the that the connection only uses nailed channels by setting Call-Type to FT1 (fractional T1):

admin> set call-type=ft1

12Write the profile: admin> write

Configuring the IP-Route profile

Next, to properly route traffic to machines on the DSLPipe unit’s LAN:

1Create a new IP Routing profile:

admin> new ip-route sdsl-pipeline

2Set the address to route equal to the Pipeline's LAN address: admin> set dest-address=192.168.216.1/24

3Set the gateway to the interface address assigned to the DSLPipe: admin> set gateway-address=192.168.23.141

4Write the profile: admin> write

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide 17-31