Configuring MultiDSP Cards

6

 

(MAX TNT, APX 8000)

 

 

 

Introduction to MultiDSP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1

Supported MultiDSP services . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3

Obtaining status information about a MultiDSP card . . . . . . . . . . . . . . . . . . . . . . . . . . 6-5

Configuring a MultiDSP card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-6

Introduction to MultiDSP

The MultiDSP card is a highly versatile, digital signal processor (DSP) slot card for

MAX TNT and APX 8000 units.

The following services are supported by the MultiDSP card:

Data (digital, analog)

V.110 rate adaption standard for ISDN

Personal Handyphone System (PHS), supporting PHS Internet Access Forum Standards (PIAFS) 1.0, 2.0, 2.1

Voice over IP (VoIP), including real-time fax functionality (MAX TNT only)

The MultiDSP support provided by a particular MultiDSP card or MAX TNT and APX 8000 unit depends on the following factors:

The type of MultiDSP card(s) installed in the unit

Software licenses (hash codes) currently downloaded on the unit shelf controller

MultiDSP card use constraints (See “Card configuration constraints” on page 6-3for details.)

Analog modem service is, by default, always enabled. Each additional MultiDSP service has a software license (hash code) that must be downloaded to the unit shelf controller for the particular service to be enabled on a MAX TNT or APX 8000 unit. The hash codes enable different types of calls to be serviced by the same DSP port on the card.

The MultiDSP services currently enabled (licensed) on MAX TNT and APX 8000 units can be viewed in the Base profile. For details, see the“Configuring a MultiDSP card” on page 6-6.

MAX TNT and APX 8000 units support two types of MultiDSP cards—a 48-port card and a 96-port card. Each MultiDSP card type supports slightly different services. Following are descriptions of each card.

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

6-1

Page 61
Image 61
Lucent Technologies 7820-0802-003 manual Configuring MultiDSP Cards MAX TNT, APX, Introduction to MultiDSP