Configuring Call Routing
Working with Call-Route profiles
The next set of commands creates another
admin> new
admin> set preferred-source = { { 1 2 2 } 0 }
admin> write
Note that the default
admin> get
Example with six E1 lines in an MFR bundle
If the MFR bundle aggregates enough bandwidth to utilize all of the channels on a Hybrid Access card (up to 186, or six E1 lines), you can create a single
For example, the following commands modify the default
admin> read
admin> set preferred-source = { { 1 16 0 } 0 }
admin> list
[in
admin> write
Concentrating multilink calls on one Hybrid Access card
Multilink calls that add channels dynamically might inadvertently use channels distributed across multiple Hybrid Access cards, which causes a performance penalty for those calls. You can use
In this example, the system has three T1 cards installed in slots 1, 2, and 3. Slot 1 uses trunk groups 4 and 5, slot 2 uses trunk groups 6 and 7, and slot 3 uses trunk groups 8 and 9. The system also has three Hybrid Access cards, in slots 4, 5, and 6.
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide |
