Lucent Technologies 7820-0802-003 manual My Addr=10.10.73.1/24, Rem Addr=104.178.115.163/24

Configuring DSL Connections (DSLTNT)

Sample DSL configurations

2Specify the following values:

–Chan Usage=Leased/Unused

–My Name=dslpipe

–My Addr=10.10.73.1/24

–Rem Name=max-tnt

–Rem Addr=104.178.115.163/24

–Route=IP

–Bridge=No

3From the Main Edit menu, select Ethernet > Connections > max-tnt.

4Specify the following values:

–Active=Yes

–Encaps=PPP

–Bridge=No

–Route IP=Yes

5Open the Encaps Options submenu.

6Specify the following values:

–Send Auth=PAP

–Send PW=PAP

–Recv PW=PAP

–Link Comp=None

–VJ Comp=No

7Open the Telco Options submenu.

8Specify the following values:

–Call Type=Nailed

–Group=1

9Exit the Connection profile and save your changes.

Sample SDSL Frame Relay configuration using numbered interfaces

This section describes a common SDSL application. In this example, the SDSL line is a leased connection over a single pair of wires, using Frame Relay as the transport protocol (see Figure 17-5). The example uses interface-based routing on a point-to-point link. Each side of the connection is assigned a unique address that applies only to the connection.

This example uses SDSL, but you can configure an ADSL connection similarly.

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide 17-29