Lucent Technologies 7820-0802-003 manual Overview of E1 FrameLine configuration

Configuring E1 FrameLine Cards (MAX TNT, DSLTNT)

Overview of E1 FrameLine configuration

PPP

The E1 FrameLine slot card supports PPP as follows:

•Only one PPP session per line.

•Bandwidth per session is 1-31 DS0 channels. Channel 1 is not available.

•Channels need not be contiguous.

•Multilink Protocol (MP) and Multilink Protocol Plus (MP+) are not supported. The connection profile must specify only PPP.

•Users are authenticated by the local profile or RADIUS.

•Stac compression is not supported.

Frame Relay

The E1 FrameLine slot card supports Frame Relay as follows:

•Only one Frame Relay link, possibly containing multiple data-link connection identifiers (DLCIs), can be active per line.

•Bandwidth per link is 1-31 DS0 channels. Channel 1 is not available.

•Channels need not be contiguous.

•Up to 120 PVCs are supported per card.

Routing protocols

The E1 FrameLine slot card supports only IP routing.

RADIUS

The E1 FrameLine slot card supports the same RADIUS accounting and authentication as the digital modem cards.

SNMP

The E1 FrameLine slot card supports SNMP as follows:

•DS1 status and management are the same as for the eight-port E1 card.

•The E1 FrameLine slot card supports the accounting Management Information Base (MIB) for session information.

Overview of E1 FrameLine configuration

Configuring the E1 FrameLine slot card is similar to E1 slot card configuration except that the

E1 FrameLine slot card has the following configuration restrictions:

•Signaling-mode must be set to E1-No-Signaling.

•Frame-Type must be set to G703.

•T-Online-Type must be set to None.

10-2 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide