Lucent Technologies 7820-0802-003 manual Overview of E1 configuration

Configuring E1 Cards

Overview of E1 configuration

Table 9-1. E1 line configuration tasks (continued)

Section	Description of task	Associated parameters
“Configuring a back-to-back	A back-to-back connection lets you connect	Back-to-Back
connection” on page 9-7	two TAOS units to one another over a
	crossover E1 cable.
“Specifying the framing” on	Framing specifies how the bits are sent on the	Frame-Type
page 9-7	line.
“Specifying E1 signaling” on	Specify the type of signaling used for your E1	Signaling-Mode
page 9-8	line.
“Configuring ISDN PRI	You must specify the type of network switch	Switch-Type
signaling” on page 9-8	providing ISDN service on an E1 PRI line.
“Configuring ISDN network-side	ISDN emulation enables you to build, send,	ISDN-Emulation-Side
emulation” on page 9-9	receive, and process ISDN data.
“Configuring E1 R1 signaling” on	R1 is a multifrequency inband signaling	Signaling-Mode
page 9-10	protocol that uses a set of register signals	Switch-Type
	known as MFR1 tones as addressing signals.
“Configuring E1 R2 signaling” on	Specify R2 signaling and specify R2-specific	Signaling-Mode
page 9-10	configuration options.	Number-Complete
		Group-B-Signal
		Group-II-Signal
		Answer-Delay
“Configuring DPNSS signaling”	Specify Digital Private Network Signaling	Signaling-Mode
on page 9-12	System (DPNSS) signaling and associated	Layer3-End
	options.
		Layer2-End
		NL-Value
		Loop-Avoidance
“Configuring overlap receiving on	T1 or E1 PRI lines with overlap receiving	Signaling-Mode
PRI lines” on page 9-13	enable the TAOS unit to gather the complete	Overlap-Receiving
	called number from the network switch via a
		PRI-Prefix-Number
	series of Information messages, enabling the
	use of features such as called-number	Trailing-Digits
	authentication.
		T302-Timer
“Configuring clocking” on	Set Clock-Source to specify whether the E1	Clock-Source
page 9-13	line can be used as the master clock source	Clock-Priority
	for synchronous connections.
	Also specify the priority of the E1 lines to be
	used for clocking.

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide 9-3