About This Guide

What is in this guide

!

!

This guide provides the following instructions for an APX 8000™ , MAX TNT® , or DSLTNT™ multiservice access concentrator:

Basic configuration of your unit

Configuring shelf controller redundancy (APX 8000 only)

Configuring Ethernet and modem cards

Configuring T1, E1, DS3, and other network slot cards

Configuring the unit in a Signaling System 7 (SS7) network

Configuring call routing

Provisioning the switch

Note: This manual describes the full set of features for APX 8000, MAX TNT, and DSLTNT units running True Access™ Operating System (TAOS) software version 8.0.2 or later. Some features might not be available with earlier versions or specialty loads of the software.

This manual hereafter refers to your product as a TAOS unit except when referring to features specific to a particular unit.

Warning: Before installing your TAOS unit, be sure to read the safety instructions in the Access Networks Safety and Compliance Guide. For information specific to your unit, see the “Safety-Related Electrical, Physical, and Environmental Information” appendix in your unit’s hardware installation guide.

What you should know

This guide is for the person who installs, configures, and maintains a TAOS unit. To configure a unit, you need to understand the following:

Wide Area Network (WAN) concepts

Local Area Network (LAN) concepts

Dial-in LAN connections such as Point-to-Point Protocol (PPP) and Multilink PPP (MP)

Connection cost management and accounting

Modems

Frame Relay

Asynchronous Transfer Mode (ATM)

IP routing

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

xvii

Page 17
Image 17
Lucent Technologies 7820-0802-003 manual About This Guide, What is in this guide, What you should know