Lucent Technologies 7820-0802-003 manual Parameter Specifies, Admin read t1 1 5

Configuring T1 Cards

Configuring T1 R1 and R1-Modified (Taiwan) with ANI and called-number processing

the switch, you can also specify how long it waits before sending the request, and how long the ANIR signal lasts.

The following parameters enable R1 signaling on T1 lines and specify the timing of certain signals from the switch. These parameters are shown with their default settings:

[in T1/{ any-shelf any-slot 0 }:line-interface] signaling-mode = inband

r1-use-anir = no

r1-first-digit-timer = 240

r1-anir-delay = 350

r1-anir-timer = 200

r1-modified = no

Parameter	Specifies
Signaling-Mode	For T1 R1 signaling, you must set Signaling-Mode to R1-Inband.
R1-Use-ANIR	Enables/disables ANI processing (CLID). It is set to No by
	default. If set to Yes, the system performs ANI processing on
	incoming calls.
R1-First-Digit-Timer	Time in milliseconds to wait for the first digit from the switch after
	sending the KP pulse. The default setting is 340 ms. The valid
	range is from 0 to 1000.
R1-ANIR-Delay	Time in milliseconds to wait before sending the ANIR signal after
	receipt of the ST pulse from the switch. The default setting is
	350 ms. The valid range is from 300 to 2000.
R1-ANIR-Timer	Duration in milliseconds of the ANIR signal. The default setting is
	200 ms. The valid range is from 180 to 400.
R1-Modified	Enables/disables a modified version R1 signaling that is required
	in Taiwan. It is set to No by default, which indicates regular R1
	signaling (described in the ITU recommendation Q.310- 332).
	TAOS units located in Taiwan must set this parameter to Yes.

Following is an example that shows how to configure R1-Modified signaling (Taiwan) with ANIR in a T1 profile:

admin> read t1 { 1 5 1}

T1/{ shelf-1 slot-5 1 } read admin> set line signal = r1-inbandadmin> set line r1-use-anir = yes

admin> set line r1-first-digit-timer = 360 admin> set line r1-anir-delay = 360 admin> set line r1-anir-timer = 220 admin> set line r1-modified = yes

admin> write

T1/{ shelf-1 slot-5 1 } written

7-16 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide