Configuring DSL Connections (DSLTNT)

Configuring data transfer rates

Configuring data transfer rates

You can configure DSL upstream and downstream rates in the line profiles for each card, and in Connection or RADIUS profiles. The data transfer rates in the line profiles apply to the port. The data rate limits in Connection or RADIUS profiles apply only to sessions using that particular profile.

Configuring session rate limits enables you allocate portions of a DSL connection’s bandwidth to particular users. For information, see “Configuring per-session data transfer rates” on page 17-8.

Table 17-1describes the parameters that determine the data transfer rates on the DSLTNT. For detailed information about these parameters, see the APX 8000/MAX TNT/DSLTNT Reference.

Table 17-1.DSL data rate configuration parameters

Parameter

Cards it applies to

 

 

SDSL line profile

 

Data-Rate-Mode

SDSL

Max-Rate

24 port SDSL only

 

 

ADSL-CAP or ADSL-DMT line profile

 

Data-Rate-Mode

ADSL-CAP, ADSL-DMT

Max-Up-Stream-Rate

ADSL-CAP, ADSL-DMT

Max-Down-Stream-Rate

ADSL-CAP, ADSL-DMT

 

 

Connection profile > Session-Options

 

Ses-ADSL-Dmt-Up-Rate

ADSL-DMT

Ses-ADSL-Dmt-Down-Rate

ADSL-DMT

Ses-ADSL-Cap-Up-Rate

ADSL-CAP

Ses-ADSL-Cap-Down-Rate

ADSL-CAP

Ses-Rate-Mode

ADSL-CAP, ADSL-DMT, SDSL

Ses-Rate-Type

ADSL-CAP, ADSL-DMT, SDSL

Ses-SDSL-Rate

SDSL

Rx-Data-Rate-Limit

SDSL

Tx-Data-Rate-Limit

SDSL

 

 

Configuring data transfer rates for ADSL lines

The Max-Down-Stream-Rate parameter in the ADSL-DMT and ADSL-CAP line profiles specifies the maximum downstream rate that the transceiver supports. If loop quality is poor, the transceiver chooses the lower rates, and good loop quality causes the transceiver to choose the higher rates. If the loop quality is very poor, the transceiver will not train at all, and will be unable to connect to the remote side. In that case, you must specify a lower maximum downstream rate, because the transceiver does not cross rate boundaries.

17-6

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

Page 158
Image 158
Lucent Technologies 7820-0802-003 manual Configuring data transfer rates for Adsl lines, Parameter Cards it applies to