Configuring DSL Connections (DSLTNT)

Configuring DSLPipe Plug and Play

Configuring the DSLTNT

DSLPipe Plug and Play support requires the following configuration on the DSLTNT:

BOOTP Relay enabled

A nailed DSL connection to the DSLPipe

A Frame Relay profile that makes use of the DSL line

A Connection profile for each DSLPipe unit

This section does not include the DSLTNT IP and DNS configurations, which are required for Plug and Play to work. For details about configuring IP routing and DNS, see the

APX 8000/MAX TNT/DSLTNT WAN, Routing and Tunneling Configuration Guide.

Configuring BOOTP Relay

The DSLTNT must be set up for BOOTP Relay to support Plug and Play in DSLPipe units. When you enable BOOTP Relay, the DSLTNT can forward DHCP request packets to a DHCP server and forward DHCP responses back to the requesting client.

If more you specify more than one DHCP server, the DSLTNT uses the first server until it becomes unavailable. Once it starts using the second DHCP server, it continues using that server until it becomes unavailable, at which time it switches back to using the first server again.

To enable BOOTP Relay, proceed as in the following example:

1Read the IP-Global profile:

admin> read ip-global

IP-GLOBAL read

2List the BOOTP-Relay profile:

admin> list bootp-relay

[in IP-GLOBAL:bootp-relay] active = no

bootp-servers = [ 0.0.0.0 0.0.0.0 ]

3Activate BOOTP Relay: admin> set active=yes

4Specify a DHCP server using the BOOTP-Servers setting. For example: admin> set bootp-servers 1 =192.168.7.62

5If necessary, specify a second DHCP server. For example: admin> set bootp-servers 2 =192.168.7.72

6Write the IP-Global profile to save your changes:

admin> write IP-GLOBAL written

Configuring the SDSL profile

In the following example procedure, the network administrator configures an SDSL line in slot 3 of the DSLTNT:

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

17-15

Page 167
Image 167
Lucent Technologies 7820-0802-003 manual Configuring the Dsltnt, Configuring Bootp Relay, Configuring the Sdsl profile