Configuring MultiDSP Cards (MAX TNT, APX 8000)
Configuring a MultiDSP card
Viewing call-routing database entries
Unlike the Call Route profiles, entries in a
When a card comes up, the MAX TNT or APX 8000 unit creates a
•Type
•Enabled MultiDSP services. (Analog modem service is always enabled.)
A call route entry is created for each available port and each enabled service. To view the entries in the
Note: For the
For example, if a
admin> callroute |
|
|
|
| ||
1:05:01/0 | 0 | 0:00:00/0 | 0 |
| ||
1:05:03/0 | 0 | 0:00:00/0 | 0 | 0 |
| |
... |
|
|
|
|
|
|
1:05:95/0 | 0 | 0:00:00/0 | 0 |
| ||
1:05:01/0 | 1 | 0:00:00/0 | 0 | 0 | ||
1:05:03/0 | 1 | 0:00:00/0 | 0 | 0 | ||
... |
|
|
|
|
|
|
1:05:95/0 | 1 | 0:00:00/0 | 0 | 0 | ||
1:05:01/0 | 2 | 0:00:00/0 | 0 0 |
|
| |
1:05:03/0 | 2 | 0:00:00/0 | 0 0 |
|
| |
... |
|
|
|
|
|
|
1:05:95/0 | 2 | 0:00:00/0 | 0 0 |
|
| |
Verifying that configurations are correct for related services
Each MultiDSP service might require additional configuration for setting up that service on the unit. For additional information and procedures, see the configuration guides listed under “Documentation set” on page xxi and the latest release note.
Adding an additional MultiDSP service
To enable an additional MultiDSP service, you must perform the following steps:
1The unit must have the proper software license for the desired service. For further information about adding MultiDSP software licenses, contact your Lucent Sales Representative.
2Once the unit is licensed for the new service, delete the existing profiles for MultiDSP cards installed in the unit, and bring up the current profiles (that now include the new license).
For example, if you want to delete the profiles and then bring up the current profiles for a card installed in slot 5, enter the following commands:
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide |
