Configuring T1 Cards

Sample T1 configuration

Sample T1 configuration

This section provides an example of how to configure a T1 slot card. The example uses the following setup:

The card is in shelf 1, slot 2.

All lines use PRI signaling.

Switch type is NTI-PRI.

The line is connected to a DSX and is less than 100 feet (30.5m) long. It therefore uses the default settings for Front-End-Type and DSX-Line-Length.

All the channels are switched (the default), with the exception of channel 24, which is set for D channel signaling.

All the channels are assigned to trunk group 9 (the default).

The Default-Call-Type is digital (the default), so all calls received on this card are routed to the Hybrid Access (HDLC) card.

The rest of the line parameters are left at their default values.

To configure the T1 card as in this example:

1Create a new T1 profile:

admin> new t1

T1/{ any-shelf any-slot 0 } read

2Set the physical address for the first T1 line:

admin> set physical-address ={ 1 2 1}

This applies the changes to the T1 line in the specified slot.

3List the contents of the line profile:

admin> list line-interface enabled = no

frame-type = d4 encoding = ami clock-source = eligible

clock-priority = middle-priority signaling-mode = inband robbed-bit-mode = wink-start default-call-type = digital switch-type = att-pri

nfas-id = 0 call-by-call = 0 data-sense = normal idle-mode = flag-idle FDL = none front-end-type = dsx DSX-line-length = 1-133 CSU-build-out = 0-db

channel-config = [ { switched-channel 9 "" { any-shelf any-slot 0 } 0 } { switc+

maintenance-state = no sendDisc-val = 0

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

7-23

Page 95
Image 95
Lucent Technologies 7820-0802-003 manual Sample T1 configuration, Admin set physical-address = 1 2