
Configuring Call Routing
Working with Call-Route profiles
Parameter | Specifies |
Telephone number assigned to TAOS unit network lines. For lines | |
| that use ISDN service, the telephone number can contain a |
| subaddress, as described in “Second pass: ISDN subaddresses” on |
| page |
Source of a call. The address of a device in the system.
Type of call to be routed to the device. Valid settings include the following:
•
•
•
•
•
•
•
Outbound call routing by trunk group
If no explicit call routes are defined, the TAOS unit always routes a call to the first entry in its database that matches the call’s parameters and is in the same quadrant. Because default entries do not include trunk group specifications, this behavior can cause a call to fail when multiple T1 or E1 cards are installed and each card supports different trunk groups. The system always tries the first installed card, and does not proceed to the second card without an explicit call route instructing it to do so.
Note: When configuring trunk groups for the purpose of outbound call routing, you must specify the trunk groups both in the
In Figure
Figure 19-1. Trunk group 8 connecting to a TAOS unit
E1 {
E1 {
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide |