Lucent Technologies 7820-0802-003 manual About the Call-Route-Type parameter

	Configuring MultiDSP Cards (MAX TNT, APX 8000)
	Configuring a MultiDSP card
Call-Route profile	Associated MultiDSP service type
entry field number
1	Digital
2	PHS
3	VoIP
4	V.110

The following example shows a Call-Route profile for the VoIP service (entry is 3) on a

48-port MultiDSP card installed in slot 5:

33 12/10/1999 18:25:32 {{{shelf-1 slot-5 0} 0} 3}

About the Call-Route-Type parameter

Each Call-Route profile contains the Call-Route-Type parameters specific to that profile. The Call-Route parameters might require configuration.

One Call-Route parameter, Call-Route-Type, specifies the type of call that the MAX TNT can route to a host device. The following Call-Route-Type values apply to MultiDSP services.

Call-Route-Type values for	Description
MultiDSP services
Voice-Call-Type	Call type for analog mode calls. The unit can route voice
	bearer calls, excluding 3.1KHz audio calls, to a host
	device.
Digital-Call-Type	Call type for digital calls. The unit can route digital calls,
	including 3.1KHz audio bearer channels, to a host device.
PHS-Call-Type	Call type for PHS calls.
VOIP-Call-Type	Call type for VoIP calls. VoIP calls can be routed to a host
	device that accepts VoIP calls.
V110-Call-Type	Call type for V.110 calls. Digital calls recognized as
	containing V.110 rate-adapted bearer channels can be
	routed to a host device.

Use the read call-routeand list commands to view a specific profile’s parameters. To identify the specific profile, you must include the profile’s index. The following example shows Call Route parameters for the profile that covers the V.110 service (entry field is 4), for a unit with a MultiDSP card in slot 5:

admin> read call-route { { { shelf-1slot-5 0 } 0 } 4 } CALL-ROUTE/{ { { shelf-1 slot-5 0 } 0 } 4 }

admin> list

[in CALL-ROUTE/{ { { shelf-1 slot-5 } 0 4 }] index* = { { { shelf-1 slot-5 0 } 0 } 4 } trunk-group = 0

phone-number = ““

preferred-source = { { any-shelf any-slot 0 } 0} call-route-type = v110-call-type

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide 6-9