Lucent Technologies 7820-0802-003 Provisioning the Switch, Provisioning the switch for T1 access

Provisioning the Switch A

Provisioning the switch for T1 access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1

What you need from your T1 service provider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2

What you need from your E1 service provider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2

This appendix provides the information necessary for properly provisioning a switch for T1/EI or T1/E1 PRI access to the WAN.

Provisioning the switch for T1 access

If you use an inband signaling line, the T1 circuit at the Point-of-Presence (POP) must support the translations listed in Table A-1for compatibility with the DSLTNT.

Table A-1. T1 access provisioning information

Translation	Optional or required
Two-state DTMF (Dual-Tone	Required for outdial.
Multifrequency) dialing
Outgoing wink start	Required for outdial.
Incoming immediate seizure	Optional for a switch.
Incoming wink start	Optional for a switch.
Incoming digits suppressed	Required.
Answer supervision	Required.
Switched data	Required.
	No voice/digital loss plan is allowed.

Four-state A-bit signaling, four-state B-bit signaling, and pulse dialing are not supported.

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide A-1