Configuring DSL Connections (DSLTNT)

Sample DSL configurations

Configuring the ADSL profile

To configure the ADSL profile in this example:

1Read in the ADSL profile:

admin> read adsl-cap {1 7 3}

2Enable the port:

admin> set enabled=yes

3List the contents of the Line-Config profile: admin> list line-config

[in ADSL-CAP/{ shelf-1 slot-7 3 }:line-config] trunk-group = 0

nailed-group = 0 activation = static

call-route-info = { any-shelf any-slot 0 } max-down-stream-rate = 7168000

4Assign this port to a nailed group:

admin> set nailed-group=73

This nailed group points to the Connection profile you will create later. The nailed group must be unique for each active WAN interface.

5Specify the maximum downstream rate:

admin> set max-down-stream-rate=7168000

6Write the profile: admin> write

Configuring the Connection profile

To configure the Connection profile in this example:

1Create a new Connection profile: admin> new connection dslpipe

2Enable the profile:

admin> set active=yes

3Set the encapsulation type to PPP:

admin> set encapsulation-protocol=ppp

4List the IP-Options submenu: admin> list ip-options

[in CONNECTION/dslpipe:ip-options] ip-routing-enabled = yes vj-header-prediction = yes remote-address = 0.0.0.0/0 local-address = 0.0.0.0/0

..

..

5Set the IP address of the DSLPipe connecting to the DSLTNT: admin> set remote-address=10.10.73.1/24

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

17-27

Page 179
Image 179
Lucent Technologies 7820-0802-003 manual Configuring the Adsl profile, List the IP-Options submenu admin list ip-options