Configuring DSL Connections (DSLTNT)
Configuring data transfer rates
To configure the maximum transfer rate for the
1Open the SDSL profile:
admin>read sdsl {2 1 7}
SDSL/{
2Enable the line:
admin>set enabled=yes
3List the
admin> list line-config
[in SDSL/{
4Specify a maximum rate:
admin> set max-rate=1552000
5Write the profile: admin> write
Configuring per-session data transfer rates
The DSL cards support configuring
You can use two different methods to configure the
In modem rate control, the DSLTNT initially establishes a CPE session at the maximum available data rate. If the CPE specifies a lower data rate, the DSLTNT terminates the session, then reestablishes it at the rate specified by the CPE . The next time the CPE initiates a connection, the DSLTNT does not retrain if the initial rate is the same or lower than the rate used previously for that CPE.
In
Following are the Connection profile parameters for configuring
Parameter/RADIUS attribute | Specifies |
Type of DSL connection to rate control. Disabled (the | |
default) means that modem rate control is not active | |
| for the connection. Currently, Disabled and |
|
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide |
