Configuring DSL Connections (DSLTNT)

 

Configuring data transfer rates

 

 

Parameter/RADIUS attribute

Specifies

Ses-Rate-Mode/

Per-session DSL data rate mode. The default setting,

Ascend-Dsl-Rate-Mode (97)

Autobaud, specifies that the DSLTNT must train up

 

to a set data rate. If a DSL modem cannot train to this

 

data rate, it will connect at the closest rate to which it

 

can train (the modem’s ceiling rate). Currently

 

Autobaud is the only supported option.

Ses-ADSL-CAP-Up-Rate/

Per-session ADSL-CAP upstream data rate. Not

Ascend-DSL-Upstream-Limit (98)

currently supported.

Ses-ADSL-CAP- Down-Rate/

Per-session ADSL-CAP downstream data rate. The

Ascend-DSL-Downstream-Limit (99)

following rates (in bits per second) are supported:

 

7168000 (the default), 6272000, 5120000, 4480000,

 

3200000, 2688000, 2560000, 2240000, 1920000,

 

1600000, 1280000, 960000, 640000.

Ses-ADSL-DMT-Up-Rate/

Not currently supported.

N/A

 

Ses-ADSL-DMT- Down-Rate/

Not currently supported.

N/A

 

Rx-Data-Rate-Limit/

Maximum data rate (in kilobits per second) to be

N/A

received across the connection. The default 0 (zero)

 

disables the data rate limit feature. The valid range is

 

from 0 to 64000. If the specified number is larger

 

than the actual bandwidth provided by the line, the

 

connection behaves as if the data rate limit were

 

disabled, except that additional computations are

 

performed unnecessarily.

Tx-Data-Rate-Limit/

Maximum data rate in kilobits per second to be

N/A

transmitted across the connection. The default 0

 

(zero) disables the data rate limit feature. The valid

 

range is from 0 to 64000. If the specified number is

 

larger than the actual bandwidth provided by the line,

 

the connection behaves as if the data rate limit were

 

disabled, except that additional computations are

 

performed unnecessarily.

For more information about these parameters, see the APX 8000/MAX TNT/DSLTNT

Reference.

Configuring per-session data rates using modem rate control

In the following example, the CPE session will be initially established at the maximum line rate configured in the ADSL-CAP profile. After the session has been established, the DSLTNT determines that this session has a maximum downstream rate of 7168000. It then re-establishes the connection using the specified rate.

admin> read conn adslpipe-1

CONNECTION/adslpipe-1 read

APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide

17-9

Page 161
Image 161
Lucent Technologies 7820-0802-003 Configuring per-session data rates using modem rate control, Admin read conn adslpipe-1