Lucent Technologies 7820-0802-003 manual Configuring per-session data rate limits

Configuring DSL Connections (DSLTNT)

Configuring data transfer rates

admin> set session ses-rate-type = adsl-cap

admin> set session ses-adsl-cap-down-rate = 7168000

admin> write CONNECTION/adslpipe-1 written

Following is a comparable RADIUS profile:

adslpipe-1 Password = "pipepw", User-Service = Framed-User Framed-Protocol = PPP,

Framed-Address = 10.2.3.31,

Framed-Netmask = 255.255.255.0,

Ascend-Dsl-Rate-Type = Rate-Type-AdslCap,

Ascend-Dsl-Rate-Mode = Rate-Mode-AutoBaud,

Ascend-Dsl-Downstream-Limit = adslcap-dn-7168000

Configuring per-session data rate limits

You can configure transmit and receive data rate limits for individual connections that use the CAP-ADSL, SDSL, and unchannelized DS3 cards. ISPs can use these configuration parameters to limit bandwidth for a connection according to the rate charged for the account.

Note: If the parameters are set for a connection that does not use these cards, the system ignores the settings.

To configure an SDSL per-session data rate, proceed as in the following example:

1Read in a Connection profile

admin> read connection sdsl-1 CONNECTION/sdsl-1 read

2List the Session-Options profile: admin> list session-options

[in CONNECTION/sdsl-1:session-options]

..

..

..

rx-data-rate-limit = 0 tx-data-rate-limit = 0

3Specify a maximum receive rate:

admin> set rx-data-rate-limit=64000

4Specify a maximum transmit rate:

admin> set tx-data-rate-limit=64000

5Write the profile: admin> write

Sample log session showing rate control negotiation

The following log messages show an incoming call from the user named adslpipe-1. The connection is authenticated via RADIUS. After establishing the LAN session, the DSLTNT reads the data rates:

17-10 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide