Lucent Technologies 7820-0802-003 Verifying call routes for MultiDSP services, Admin dir call-r

Configuring MultiDSP Cards (MAX TNT, APX 8000)

Configuring a MultiDSP card

...

phs-support = yes

...

voip-enabled = no

...

v110-enabled = disabled

...

rtfax-enabled = no

...

Verifying call routes for MultiDSP services

You can verify call routes for enabled MultiDSP services by viewing the Call-Route profiles and the call route entries. Procedures for viewing the Call-Route profiles and entries are described in this section.

Viewing the Call-Route profile and its Call-Route-Type parameter

When a 48-port or 96-port MultiDSP card is initially detected by the unit, the unit creates Call-Route profiles for each MultiDSP service—modem, digital, PHS, VoIP or V.110.

Use the dir call-rcommand to display the Call Route profiles. The following example displays Call Route profiles for a 48-port card (indicated by madd) installed in slot 5 of a MAX TNT unit:

admin> show

Shelf 1 ( standalone ):

{ shelf-1 slot-5 0 } UP madd-card

admin> dir call-r

30 12/07/1999 10:22:12 {{{shelf-1 any-slot 0} 0} 0} 33 12/10/1999 18:25:32 {{{shelf-1 slot-5 0} 0} 0} 33 12/10/1999 18:25:32 {{{shelf-1 slot-5 0} 0} 1} 33 12/10/1999 18:25:32 {{{shelf-1 slot-5 0} 0} 2} 33 12/10/1999 18:25:32 {{{shelf-1 slot-5 0} 0} 3} 33 12/10/1999 18:25:32 {{{shelf-1 slot-5 0} 0} 4}

The first entry is the system default. The other profiles are for each of the MultiDSP services. You can edit the profile list to include only currently enabled MultiDSP services.

Each profile contains an index that uses the following format:

{{{shelf slot port} logical-item}entry}

The system index is the following:

{{{shelf-1 any-slot 0} 0} 0}.

Each MultiDSP service has a unique entry field number. The following table displays the entry number associated with each MultiDSP service type:

Call-Route profile	Associated MultiDSP service type
entry field number
0	Analog modem

6-8 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide