Lucent Technologies 7820-0802-003 manual Chapter Configuring the Thermal Profile for Fan

Contents

	Configuring the APX 8000 for shelf-controller redundancy	2-3
	Assigning the system IP address	2-4
	Assigning an Ethernet IP address	2-4
	Examples of setting shelf-controller Ethernet IP address	2-4
	Defining the soft IP interface for fault tolerance	2-5
	Example of setting the soft IP address	2-5
	Configuring shelf-controller redundancy	2-6
	Physical interface profiles	2-6
	Redundancy profile	2-6
	Switching the primary controller at the command-line interface	2-8
	Resetting shelf controllers and clearing controller NVRAM	2-8
	Resetting the controllers	2-8
	Clearing NVRAM	2-9
	Obtaining status information about redundant shelf controllers	2-9
	Viewing controller up time	2-9
	Viewing controller status	2-10
	Setting up a trap to monitor the secondary controller	2-11
	Clearing the fatal-error history log	2-11
Chapter 3	Configuring the Thermal Profile for Fan
	Tray Operations (APX 8000)	3-1
	Overview of the Thermal profile for fan tray operations	3-1
	Example of configuring thermal controls	3-2
	Related log messages	3-3
	Thermal alarms	3-3
	Thermal status reporting	3-4
	Fanstatus command	3-4
	Thermalstatus command	3-5
Chapter 4	Configuring Ethernet Cards	4-1
	Introduction to Ethernet slot cards	4-1
	Full-duplex 10/100Mbps Ethernet-2 slot card	4-1
	Full-duplex 10/100Mbps Ethernet-3 slot card	4-1
	Upgrading to the Ethernet-2 and Ethernet-3 slot cards	4-2
	Overview of Ethernet configuration	4-2
	Understanding the Ethernet-related profiles	4-2
	Ethernet profile	4-2
	IP-Interface profile	4-3
	Configuring duplex mode on the 100Mbps Ethernet port	4-3
Chapter 5	Configuring Series56 II and
	III Modem and Hybrid Access Cards	5-1
	..........................................................................................................
	Overview of configuring modem cards	5-1
	Specifying modem negotiation settings	5-2
	Specifying modem modulation for Series56 II and III modem cards	5-3
	Configuring an additional AT answer string for modem calls	5-3
	Series56 II and III Call-Route profiles	5-4
	Preventing Series56 II and III cards from delaying Frame Relay connections	5-5
	Hybrid Access card implementation	5-5

vi APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide