Nortel Networks 450 manual IP Configuration/Setup Screen Stack Configuration

Using the BayStack 450 10/100/1000 Series Switch

4.Select IP Configuration/Setup (or press i) from the Main Menu. This selection displays the IP Configuration/Setup screen (Figure 2-17).

Note: The IP interface of the BayStack 450 switch is only on VLAN 1. You can manage the switch only from VLAN 1 (or via routers that connect VLAN 1 to the network management station).

IP Configuration/Setup

BootP Request Mode: [ BootP Disabled			]
	Configurable	In Use		Last BootP
	-------------------	---------------		---------------
In-Band Stack IP Address:	[ 0.0.0.0 ]			0.0.0.0
In-Band Switch IP Address: [ 0.0.0.0 ]				0.0.0.0
In-Band Subnet Mask:	[ 0.0.0.0 ]	0.0.0.0		0.0.0.0
Default Gateway:	[ 0.0.0.0 ]	0.0.0.0		0.0.0.0

Use space bar to display choices, press <Return> or <Enter> to select choice. Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.

Figure 2-17. IP Configuration/Setup Screen (Stack Configuration)

5.Enter the Stack IP address in the In-Band Stack IP Address field, then press [Return].

The In-Band Switch IP Address field (directly below the In-Band Stack IP Address field) is not required for the operation of the stack. The In-Band Switch IP Address field allows this switch to operate as a standalone switch. You cannot configur both IP address fields to use the same IP address.

2-22 302401-D Rev 00