Nortel Networks 450 manual Renumber Stack Units Screen

Using the Console Interface

Renumber Stack Units

The Renumber Stack Units screen (Figure 3-26) allows you to renumber the units configured in the stack. When selected, this option identifies the unit number of each unit in the stack configuration by lighting the corresponding number of (100 Mb/s port) LEDs on each unit for approximately 10 seconds. For example, unit 3 will display three LEDs.

Note: This menu option and screen only appear when the switch is participating in a stack configuration.

Choose Renumber Stack Units (or press n) from the main menu to open the Renumber Stack Units screen.

			Renumber Stack Units
Current Unit Number			MAC Address	New Unit Number
-------------------			----------------------------	---------------
[	1	]	00-60-fd-77-a6-0c	[	1	]
[	2	]	00-60-fd-77-a5-f0	[	2	]
[	3	]	00-60-fd-77-a4-4c	[	3	]
[	4	]	00-60-fd-77-ab-84	[	4	]

Renumbering stack units will cause an automatic Reset to Current Settings to occur across the entire stack. The current configuration will be adapted to the new numbering scheme. Check the stack configuration after the reset to confirm the desired configuration is set.

Are you sure you want to renumber switches with the new settings? [ No ]

Use space bar to display choices, press <Return> or <Enter> to select choice. Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.

Figure 3-26. Renumber Stack Units Screen

302401-D Rev 00 3-65