Using the Console Interface

Display Event Log

This section describes the various functions of the Event Log screen (Figure 3-35).

When the switch is part of a stack configuration, the Event Log screen displays only the data for the specific unit you are connected to through the Console/ Comm port. However, if you are connected to a stack unit through a TELNET session, the Event Log screen displays the data for the base unit of that stack configuration.

Note: This screen does not refresh dynamically to show new entries. To refresh the screen, press [Ctrl]-P.

Choose Display Event Log (or press e) from the main menu to open the Event Log screen.

 

Event Log

 

Entry Number: 4

sysUpTime: 00:14:36

Reset Count: 2

Connection logout, IP address: 38.227.40.8, access mode: no security.

Entry Number: 3 sysUpTime: 00:13:35 Reset Count: 2

Connection logout, IP address: 38.227.40.8, access mode: no security.

Entry Number: 2

sysUpTime: 00:00:53

Reset Count: 2

Successful connection from IP address: 38.227.40.8, access mode: no security.

Entry Number: 1 sysUpTime: 00:00:00 Reset Count: 1 Software downloaded to BayStack Model 450-24T HW:RevA FW:V1.00 SW:V1.0.0.0

Press Ctrl-P to see previous display. Press Ctrl-N to see more entries. Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.

Figure 3-35. Event Log Screen

302401-D Rev 00

3-85

Page 217
Image 217
Nortel Networks 450 manual Display Event Log, Event Log Screen