Nortel Networks 450 manual Point

Using the BayStack 450 10/100/1000 Series Switch

Table 3-3. SNMP Configuration Screen Fields (continued)

Field

Read-Write Community String

Trap #1 IP Address1

Community String

Authentication Trap

Link Up/Down Trap

Description

The community string used for in-band read-write SNMP operations.

Default Value	private
Range	Any ASCII string of up to 32 printable characters

Number one of four trap IP addresses. Successive trap IP address fields are numbered 2, 3, and 4. Each trap address has an associated community string (see Community String).

Default Value	0.0.0.0 (no IP address assigned)
Range	Four-octet dotted-decimal notation, where each octet is
	represented as a decimal value, separated by a decimal
	point

The community string associated with one of the four trap IP addresses (see Trap #1 IP Address).

Default Value	Zero-length string
Range	Any ASCII string of up to 32 printable characters

Determines whether a trap will be sent when there is an SNMP authentication failure.

Default Value	Enabled
Range	Enabled, Disabled

Determines whether Link Up or Link Down traps will be sent from the switch.

Default Value	Enabled
Range	Enabled, Disabled

1 The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel Networks proprietary MIB). The status of the row in the MIB table can be set to Ignore. If the row status is set to Ignore, the fields appear to be set when viewed from the console terminal; however, no traps will be sent to that address until the row status is set to Valid.

3-14 302401-D Rev 00