Nortel Networks 450 manual Default Settings

		Default Settings
Table F-1.	Factory Default Settings for the BayStack 450 Switch (continued)
Field	Default setting	Appears in this CI screen
Unit	1	Port Configuration (page 3-32)
Status	Enabled (for all ports)
Autonegotiation	Enabled (for all ports)
Speed/Duplex	100Mbs/Half (when
	Autonegotiation is Disabled)

Unit	1 to 8 (depending on
	configuration status)

High Speed Flow Control Configuration (page 3-34)

AutonegotiationEnabled

Flow Control Disabled

Note: The following two fields only appear when a single Phy MDA with a separate redundant Phy port is installed.

Preferred Phy	Right
Active Phy	Read-only field indicating the
	operational Phy port (Right,
	Left, or None)
Trunk Members (Unit/Port)	Zero-length string	MultiLink Trunk Configuration
		(page 3-39)
STP Learning	Normal
Trunk Mode	Basic
Trunk Status	Enabled
Trunk Name	Trunk #1 to Trunk #6
Traffic Type	Rx and Tx	MultiLink Trunk Utilization (page 3-41)
Monitoring Mode	Disabled	Port Mirroring Configuration
		(page 3-45)
Monitor/Unit Port	Zero-length string
Unit/Port X	Zero-length string
Unit/Port Y	Zero-length string
Address A	00-00-00-00-00-00
	(no MAC address assigned)
Address B	00-00-00-00-00-00
	(no MAC address assigned)
		(continued)

302401-D Rev 00 F-3