Nortel Networks 450 manual Configuration File Download/Upload Screen

Using the BayStack 450 10/100/1000 Series Switch

Configuration File

The Configuration File Download/Upload screen (Figure 3-34) allows you to store your switch/stack configuration parameters on a TFTP server.

You can retrieve the configuration parameters of a standalone switch or an entire stack and use the retrieved parameters to automatically configure a replacement switch or stack. Certain requirements apply when automatically configuring a switch or stack using this feature (see “ Requirements” on page 3-83). You must set up the file on your TFTP server and set the filename read/write permission to enabled before you can save the configuration paramenters.

Although most configuration parameters are saved to the configuration file, certain parameters are not saved (see Table 3-31 on page 3-84).

Choose Configuration File (or press g) from the main menu to open the

Configuration File Download/Upload screen.

Configuration File Download/Upload

Configuration Image Filename:	[ ]
TFTP Server IP Address:	[ 132.245.164.4 ]
Copy Configuration Image to Server:	[ No	]
Retrieve Configuration Image from Server:	[ No	]

Enter text, press <Return> or <Enter> when complete.

Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.

Figure 3-34. Configuration File Download/Upload Screen

Table 3-30 describes the Configuration File Download/Upload screen fields.

3-82 302401-D Rev 00