Nortel Networks 450 manual Stack Configurations, Removing a Unit from the Stack

BayStack 450 10/100/1000 Series Switches

Removing a Unit from the Stack

If a unit is removed from the stack (therefore operating in standalone mode), the following switch configuration settings revert back to the settings configured before the unit became a member of the stack:

•IP address

•Console password

•TELNET password

•SNMP community strings

Stack Configurations

As shown in Figure 1-12, the cascade connectors and cables on the 400-ST1 front panel provide the ability to stack up to eight BayStack switches. With 400-4TX MDAs installed in each switch, the stack can accommodate a maximum of 224 switch ports.

Because stack parameters are associated with the base unit (see “ Base Unit” on page 1-25), the physical stack order depends on the base unit’s position and whether the stack is configured stack up or stack down.

302401-D Rev 00 1-27