Ricoh FAX5600L manual 237, Carefully place the document into the auto document feeder, Dial

APPENDIX C. ISDN G4 OPTION TYPE 90

Transmission Procedure

The following example shows how to dial (assuming that the ISDN G4 Option Type 90 has been installed). The differences between this procedure and the procedure for the base machine (refer to page 49) are as follows:

❐You have to select G3 or G4 before you dial a number.

❐You may have to input a subaddress for a G4 number if the destination has one.

1.Make sure that the machine is in standby mode (see page 49).

MEMORY TRANS.		APR. 4. 12:25PM
	SET DOCUMENT
		MEMORY 100%

2.Carefully place the document into the auto document feeder.

MEMORY TRANS.	OPTIONS
ENTER FAX NUMBER
<G3>

3.Change the line type (G3/G4) to the cor - rect setting by pressing the G4/G3 Se - lector key on the operation panel.

MEMORY TRANS.	OPTIONS
ENTER FAX NUMBER
<G4>

4. Dial.

See page 51 for how to dial.

You may use Speed Dial, Quick Dial,

Group Dial, or the ten-key pad.

MEMORY TRANS.	OPTIONS
PRESS YES OR CLR	. NO
7005551234_

G3 numbers - If your machine is behind a PBX, include the PBX access code and a pause before the number. For an international number, place a pause after the country code.

G4 numbers - If you wish to enter a subaddress, press the User Function Key that you have already programmed as the subaddress key. Then enter the subaddress.

To enter a subaddress, you must use a User Function Key. See page 163 for how to program a User Function Key using Function 35.

5.	Yes	MEMORY TRANS.	OPTIONS
		ENTER NO. OR START	DEST: 2
		_

6.Either:

❐Dial more numbers: go to step 4.

❐Start the transmission: Start

Note: If the other party has not had a G4 Terminal ID programmed, you will see "_ =" on the screen during transmission, instead of their ID.

APPENDIX

237