Ricoh FAX5600L manual 119, Specifying an Image Area

ADVANCED FEATURES TRANSMISSION

Changing the Specified Image Area On/Off Home Position Setting

In a new machine, this setting is off. If you change this setting to "On", the image area that you input (using Function 96; see below) will be used for all of your transmitted pages, unless you switch off the light under the User Function Key that you programmed for this feature.

1.	Function	6 0 2 2 2 2 9 1
			USER PARAMETER		PRINT LIST
			DEFAULT:	01000000
			SWITCH00:			TO END
				01000000	YES

2.The settings for switch 00 are now shown on the bottom line of the display.

3. Press ↓ until the settings for switch 03 are shown.

The setting that you need to change is digit 5.

4.If you wish to change the setting, press

5.Finish: Yes Function

Specifying an Image Area

4

Digit 5

0: The home position is "Off". After

. transmission, Specified Image Area will switch itself off.

1:The home position is "On". After transmission, Specified Image Area will stay active and the lamp under the User Function Key will stay lit.

ADVANCED FEATURES

1.Function 6 0 2 2 2 2 9 6

2.	Input the skip length then press	↓ .
	You must enter a three digit value.
	For example, for 75 mm, input 075.
3.	Input the scan length then press	↓ .

You must enter a three digit value. For example, for 95 mm, input 095.

4. Finish: Yes

IMAGE AREA			TO END
		YES
SKIP LENGTH:	000		MM
SCAN LENGTH:	000		MM
IMAGE AREA		YES	TO END
SKIP LENGTH:	075		MM
SCAN LENGTH:	000		MM

❐1 inch is 25.4 mm. You must input the dimensions in mm.

The machine returns to the transmission procedure.

Specified Image Area is available only when you are doing one of the following:

❐Memory Transmission (including Confidential Transmission and Transfer Request)

❐Storing a document for Polling Transmission

❐Storing an Auto Document

119