ROUTINE OPERATION

SENDING A FAX MESSAGE

Using the Stamp

If press the Stamp key to light the Stamp indicator, the machine stamps the bottom of each page. During memory transmission, the stamp indicates that the page was successfully stored. For immediate transmission, it shows that the page was sent successfully. You must switch the stamp on before you press Start , or the machine will not stamp the first page.

If you wish the stamp to be at the top of each page instead of at the bottom, contact your service representative.

Changing the Stamp Home Position Setting

If you wish to change the Stamp home position setting, do the following.

(See page 10 if you need more information about the User Parameter settings adjustment procedure).

1.Function 6 0 2 2 2 2 9

At this time, you can print a User

Parameter List if you press Start

1

.

USER PARAMETER

 

PRINT LIST

DEFAULT:

01000000

 

 

 

SWITCH00:

 

 

 

TO END

01000000

 

YES

 

 

 

 

 

ROUTINE

OPERATION

 

 

2.The settings for switch 00 are now shown on the bottom line of the display. The setting that you need to change is that for digit 0.

3.If you wish to change the setting, press

4.Finish: Yes Function

0

Digit 0

0:The stamp home position is "Off".

. If you press the Stamp key to use the Stamp, the Stamp will be disabled at the end of the transmission.

1:The stamp home position is "On". After the transmission, the Stamp will stay enabled.

71

Page 85
Image 85
Ricoh FAX5600L manual Using the Stamp, Changing the Stamp Home Position Setting