Section 6. Replacement Procedures
Replacing the Fuses
6.3.2 Removing and Replacing the Internal Fuse(s)
Required: | T3.15A, 250V Fuse or T1 Amp 250V Fuse |
To remove and replace these fuse(s) do the following:
STEP PROCEDURE
1.Switch the printer OFF and disconnect the power cable.
2.Raise the access door and remove (2) screws holding the side cover to the inside frame. Figs.
3.Remove (2) screws holding the side cover to the outside frame. Remove the cover to expose the electronics.
4.Refer to Fig.
5.Remove and replace the fuse(s) with one of equal rating. Do not use a fuse with a higher rating.
6.Replace the cover and replace the screws.
7.Return the printer to service by reconnecting the power cable.
FUSES
MAIN PC BOARD
Fig.
Page | SATO CL408e/CL412e Service Manual |