Section 9. Optional Accessories

Real Time Clock Installation

STEP

PROCEDURE

1.Refer to Figs. 9-42

Remove the EEPROM chip. CAUTION: Using a screwdriver to remove EEPROM may cause damage to the PCB. Be sure to have Prom remover under EEPROM and not under the socket itself.

2.Install the Real Time Clock Chip in location vacated by the EEPROM chip. Carefully align and insert the chip with the mark spot on the chip (identifying pin1) securely into the chip block socket using the “U” shaped notch as reference. Be very careful not to bend any chip legs.

3.Replace the cover reversing the removal steps.

4.Reattach and plug in the power cord.

Perform the factory reset procedure to complete the installation of firmware and Real Time Clock Chip.

PN 9001078

SATO CL408e/CL412e Service Manual

Page 9-27

Rev.B

 

 

Page 181
Image 181
SATO CL412E service manual Rev.B