SATO CL412E service manual LCD Panel Configuration, Mode KEY Sequence Initial Display

Section 2. Configuration

2.3 LCD Panel Configuration

The LCD Panel on the CL408e/CL412e is used in conjunction with the LINE and FEED switches by the operator to manually enter printer configuration settings. Many of the settings can also be controlled via software commands and in the case of conflict between software and control panel settings, the printer will always use the last valid setting. If you load a label job that includes software settings and then enter a new setting via the LCD Panel, the manually set values will be used by the printer. If you set the values manually and then download a job with software settings, the software settings will be used.

There are 7 configuration and operation modes you can access from the LCD panel. To enter the desired mode, the KEY SEQUENCE combination listed in the table below must be performed. The initial LCD display message is shown for each mode.

MODE	KEY SEQUENCE	INITIAL DISPLAY	PAGE
Normal Mode	Power	ONLINE	2-9
		QTY:000000
Advanced Mode	LINE + POWER	ADVANCED MODE	2-13
Test Print Mode	FEED + POWER	TEST PRINT MODE	2-33
		CONFIGURATION
Default Setting Mode	LINE + FEED + POWER	DEFAULT SETTING	2-34
(Std Protocol)		YES NO
Maintenance Mode	DSW2-4 ON + LINE +	MAINTENANCE MODE	2-35
	FEED + POWER	DIPSW2-4 ON->OFF
Hex Dump Mode	DSW2-4 ON + POWER	ONLINE	2-38
		QTY:000000
Firmware	DSW2-6 ON + POWER	FLASH DOWNLOAD	2-39
Download Mode		READY

Page 2-8 SATO CL408e/CL412e Service Manual

PN 9001078 Rev. B