Section 2. Configuration
LCD Panel — Advanced Mode
Print Offset | Print offset | |
| ||
| v:+0000 | H:+000 |
|
|
|
Since the printer moves the label in discrete steps equal to the size of the print dot, the units of measure for Vertical and Horizontal Offset distance is dots.
Vertical Offset is the distance down from the leading edge in dots (the edge of the label that comes out of the printer first) to the first vertical print position. A positive setting moves the first print position down the length of the label while making it negative moves it up the length of the label. The maximum value that can be set is 823 dots.
Horizontal Offset is the distance that the label image is shifted either to the right or left on the label. For a positive setting the image is shifted to the left (towards the inside edge of the label). For a negative setting the image the image is shifted to the right (towards the outside edge of the label). This setting changes the base reference point for all subsequent label jobs. The effect is identical to the <ESC>A3 Base Reference point command. The maximum value that can be set is 1424 dots.
STEP | PROCEDURE |
1.Use the LINE key to step the first digit of the counter to the desired setting. The display will increment one step each time the LINE key is pressed.
2.Press the FEED key to accept the setting and advance the cursor to the second digit. Again use the LINE key to step to the desired setting. Once it is correct, press the FEED key to advance to the next adjustment.
3.Once the setting is correct, press the FEED key to accept the setting and advance to the next display.
Print a test label after completing the adjustments to ensure it is correct. Note: This setting can be overridden by the Base Reference Point Command in your software.
Set Calendar
set calendar
YES NO
This message will only be displayed if the Calendar Option is installed in the printer.
The Calendar is an optional feature in CL408e/CL412e printers allowing the date and time to be set manually using the LCD Display or via the <ESC>WT Calendar Set command. The last setting, set either manually via software command, received by the printer will be the value used. The format of the display is YY/MM/DD hh:mm (Year/Month/Day/ hours:minutes). The date format is fixed and cannot be changed.
To enable the Calendar feature (if installed), press the LINE key until the underline cursor is beneath the YES. If the Calendar feature is to be disabled, press the LINE key until the cursor is underneath the NO. When the desired setting is selected, Press the FEED key.
Page | SATO CL408e/CL412e Service Manual |
